25/76
MP120
where “n” indicates the number of alarm repetitions. To change the number of repetitions, press
ENTER
and
select the new time by means of button ▼, then confirm the new value by pressing
ENTER
.
8. To exit the menu, press
ESC
Several times.
2.13 SYSTEM OPTIONS
Below are the system options that can be configured:
•
Key
, for mechanic key control (Pulse or Bi-static mode).
•
Buzzer
, to enable or disable (i.e. leave out) the signalling through the keyboard buzzer.
•
Pre-alarm
, to enable or disable the keyboard buzzer signalling for entry or exit time elapsing. The exit frequency
is 1 beep per second; the entry frequency is 2 beeps per second.
•
Type of actuation
, to determine the control unit behaviour if inputs in alarm condition (e.g. doors left open) are
detected upon actuation. The actuation lock, in the presence of inputs in alarm condition, avoids generating
false alarms. Possible modes include:
Standard (Std)
: the antitheft system will in any case be actuated, and all the preset alarms will be actuated if
open inputs are found.
Self-exclusion (AEX)
: the inputs in alarm condition will be automatically excluded when the system is
actuated. Self-exclusion is temporary: if the input does not signal al alarm condition any longer (e.g. the door
is closed), it will be automatically included again. Using the keyboard for the purpose of actuation allows the
user to realize whether inputs in alarm condition (and, therefore, automatically excluded) are found.
•
Actuation lock (BLK)
: sectors, to which areas being opened at that time are associated, cannot be activated
neither from keyboard nor via key. If such activation is tried from keyboard, relevant warning is given on the
display and activation does not occur.
•
Masking
, i.e. the possibility of “concealing” (masking) the system status to unauthorized people when the exit
time expires (only the mains supply status will be visible on the keyboard). Also refer to paragraph
2.5
CHOOSING THE BASE MESSAGE ON THE display
for the relationship between the masking and the sector
status displaying.
To modify the system options, proceed as follows:
1. type in the Installer code (factory setting: 000000), then press
ENTER
twice.
2. The following message will appear on the display:
Press ► until the message below appears:
Then press
ENTER
to confirm.
3. The following message will appear on the display:
Press ▼ until the message below appears:
Then press
ENTER
to confirm.
4. The following message will appear on the display:
where “xxxx” indicates the “Key” input configuration. To modify the configuration, press
ENTER
and use button
▼ to select the new configuration, then confirm the new value by pressing
ENTER
.
5. Press ▼. The following message will appear on the display:
K E Y x x x x
S y s t e m O p t i o n s
Z o n e P r o g r a m m i n g
C o n t r . P a n e l P R G
E v e n t M e m o r y
A l a r m C o u n t n
