Eco ETS Series, Руководство пользователя

Страница: 25 / 36

Product Connections Illustration
Control panel Bedix ETS Bedix Cable specification
6 4 shielded cable U72M or
7 3 EIB-Y(St)Y 2x2x0,8 mm, twisted
wires
Note: Always use a seperate cable for the Bedix and connect all wires. Double if necessary
Radio transmitter
and receiver
for rocker large surface button
(GFT)
Transmitter GFT Receiver ETS
blue black (COM) + (1) 1 (24 V)
brown blue (N.O) - (2) 3 (GND)
COM (3) 3 (GND)
N.O (5) 2 (KEY)
Key switch
ST-02-UP (HPZ)
At switch position 0 (standard)
“automatic (all control elements)
is active. At switch position 1,
one of the following functions
can be selected.
Key switch ETS-Functions
Night
(Key) Hand
(manual) One way
(only OEI)
COM 26 26 26
NO 23 24 25
NC 22 22 22
Teach in transmitter / receiver:
1. Set the receiver to operating mode 3:
Push programming button 3 x approx. 1 sec. until the LED fl ashes as follows: 3 x short - break - 3 x short
2. Keep the transmitter / button (GFT) pressed until the LED on the receiver shows 4 sec. continuous light,
then the LED fl ashes again. Now release the button (GFT) (this transmitter is now taught-in).
3. Same procedure for other transmitters / buttons as above (pos. 2).
4.
Press the programming button on the receiver once = operating mode, LED off.
5. Test the function on the GFT, blue LED must be lit on the ETS .
Light up = opening command.
Note: Connection for comparable opening buttons is identical.
25