Echo DHC-310, Руководство оператора

Страница: 9 / 225

WARNING
Remove the battery pack from the machine before
maintenance.
9.1 CLEAN THE MACHINE
WARNING
Keep the machine and the motor free of leaves, branches or
excessive oil to prevent fire risks.
• Use a moist cloth with a mild detergent to clean the
machine.
• Clean all moisture with a soft dry cloth.
• Use a small brush to clean the air vents.
9.2 LUBRICATE THE BLADE
Figure 7
To increase the efficiency and life of the blades, lubricate
them carefully after each work session:
• Put the machine on a flat and smooth surface.
• Use a soft cloth to clean the blades and a brush to remove
more dirt.
• Use a light layer of oil to lubricate the blades along the
top edge of the blade.
NOTE
We recommend to use the non-pollutant type oil.
10 STORE THE MACHINE
NOTE
Clean the machine before storage.
1. Remove the battery pack.
2. Let the motor cool.
3. Check that there are no loose or damaged components. If
it is necessary, replace the damaged components, tighten
screws and bolts, or speak to a person of an approved
service center.
4. Store the machine in a cool and dry location.
11 TROUBLESHOOTING
Problem Possible cause Solution
The motor does
not start when you
pull the trigger.
The battery pack is
not installed tight-
ly.
Make sure that
you tightly install
the battery pack in
the machine.
The battery pack is
out of power.
Charge the battery
pack.
Problem Possible cause Solution
The machine
smokes during op-
eration.
The machine has
damage.
1. Immediately
stop the ma-
chine.
2. Remove the
battery pack.
3. Speak to your
dealer.
The motor is on,
blade do not
move.
The machine has
damage.
Do not use the ma-
chine and speak to
your dealer.
The blades are
blocked.
There is too much
noise and/or vibra-
tion during opera-
tion.
The parts are
loose.
1. Stop the ma-
chine.
2. Remove the
battery.
3. Inspect for
damage.
4. Check and
tighten loose
parts.
The parts have
damage.
Do not use the ma-
chine and speak to
your dealer.
12 TECHNICAL DATA
Voltage 36 V DC, 40 V max
Blade speed 3000(±10%) cuts/min
Cutting length 604 mm
Weight (without battery
pack)
2.7 kg
Measuered sound pressure
level
82dB(A), KPA=3dB(A)
Measured sound power level 95dB(A), KWA=3dB(A)
Guaranteed sound power lev-
el
98dB(A)
Vibration <2.5 m/s2
Uncertainty 1.5 m/s2
Battery model LBP-36-80 / LBP-36-150
Charger model LC-3604
13 EC DECLARATION OF
CONFORMITY
Manufacturer: YAMABIKO CORPORATION
Address:
1-7-2 Suehirocho, Ohme, Tokyo 198-8760
JAPAN
8
English Original Instructions
EN