PX200NB
–
Manual
Page 25 / 57
7.2.1.
Service code
This code provides the highest level access to the system. It is used both for local
programming of the device and also for remote controlling (in TCP/IP or SMS mode).
Factory setting is
1111
. During the first starting of device (programming) it shall be
changed. Code may consist of up to seven alpha numerical characters.
7.2.2.
Installer code
Allows restricted access to the parameters of device. When installer code is used
following groups of parameters are unavailable: Access, Transmission, Restrictions,
SMS notifications, RS232, Link control, and Phone line. An unauthorized attempt to
access to this parameters causes error notification.
Default installer code:
2222
.
7.2.3.
User code
This code is used to authenticate the user who registers the communicator with the
EBS Security mobile application. It must be entered during registration.
NOTE!
If the code was not defined while programming the communicator, entering it
during the first registration of the device in the EBS Security application will cause
the code to be stored in the device. Subsequent change of the code can be done only
via EBS Config 2.0.
7.2.4.
SIM card 1 PIN
As a device operates via UMTS network, SIM card is indispensable and it may be
received from phone operator. Before the first use PIN code of SIM card shall be