PX200NB
–
Manual
Page 26 / 57
programmed for operation in given communicator. PIN code is indispensable for
automatic system launching. In case of card without PIN code, it is possible to enter
any value e.g. 0000.
If you enter wrong PIN number after inserting card and switching on communicator,
the system will not launch and you may be able to use card after entering PUK card
only (with use of any GSM mobile phone).
Factory setting of PIN in communicator is
1111
.
7.2.5.
Power supply and communication stability
7.2.5.1.
Report power failure longer than
Here, define the period after which a power loss will be reported.
7.2.5.2.
Mobile network watchdog
This option enables automatic reaction of a control panel after loss of connection with
a GSM mobile network or when GPRS transmission becomes impossible.
Two additional fields will appear after activating this option:
➢
React in case of no transmission for
Here, define the period of waiting until modem reset after detecting loss of network
connection (no transmission).
➢
Device reset
Here, define the period of waiting until device reset (not just a modem reset) after
detecting loss of network connection (no transmission).
7.3.
PARTITIONS
Using partitions you may configure which inputs will be monitored depending on state
of one of the inputs (arming). If arming input is not active then all changes of the
state of the input assigned to partition will be ignored. For the active arming input all
changes of the state of the input assigned to partition will be monitored and processed
in a normal way.
7.3.1.
Arming delay (time to exit)
After clicking on this option, additional list will show, where you can set the time for
exit. Partition inputs will be monitored when this configured time elapses after
partition input had been armed.
