Eaton Power Xpert 9395 UPS, Инструкция по установке и эксплуатации

Страница: 84 / 250

UPS System Installation
4-24 Power Xpert
TM
9395 UPS (450–825 kVA) Installation and Operation Manual 164201725—Rev 10 www.eaton.com/powerquality
6. Connect phase A, B, and C rectifier input power wiring from the utility source to each UPM rectifier input
terminal block in the UPS cabinet. See paragraph 3.2.3, Table 3-8, and Table 3-15 for wiring and
termination requirements
7. Proceed to Step 9.
8. Using hardware from the external wiring terminal hardware kit (see Table 3-13), connect phase A, B, and C
rectifier input power wiring from the utility source to the rectifier input terminals in the UPS cabinet. See
paragraph 3.2.3 for wiring and termination requirements.
9. If installing a UPS configured as an Input Output Module (IOM), proceed to Step 11; otherwise, proceed to
Step 10.
10. Using hardware from the external wiring terminal hardware kit (see Table 3-13), connect phase A, B, and
C, and Neutral (if required) bypass input power wiring from the utility source to the bypass input terminals
and neutral terminals in the ISBM section. See paragraph 3.2.3 for wiring and termination requirements.
11. If wiring a distributed bypass system, proceed to Step 12; otherwise, proceed to Step 14.
12. Using hardware from the external wiring terminal hardware kit (see Table 3-13), connect phase A, B, and
C, and Neutral power wiring from the output and neutral terminals of each UPS unit to the
customer-supplied tie cabinet or load distribution panel. See paragraph 3.2.3 for wiring and termination
requirements.
13. Proceed to paragraph 4.8.3.
14. Using hardware from the external wiring terminal hardware kit (see Table 3-13), connect phase A, B, and
C, and Neutral (if required) power wiring from output terminals and neutral terminals to the critical load.
See paragraph 3.2.3 for wiring and termination requirements.
15. Proceed to paragraph 4.8.3.