Eaton Power Xpert 9395 UPS, Инструкция по установке и эксплуатации

Страница: 205 / 250

UPS Operating Instructions
Power Xpert
TM
9395 UPS (450–825 kVA) Installation and Operation Manual 164201725—Rev 10 www.eaton.com/powerquality 7-43
7.4.28 Using the Remote Emergency Power-off Switch
A UPS emergency power-off is initiated by the
REPO
pushbutton switch. In an emergency, you can use this
switch to control the UPS output. The REPO switch de–energizes the critical load and powers down the UPSs
immediately, without asking for verification.
The UPS, including Bypass, remains off until restarted.
CAUTION
All power to the critical load is lost when the REPO switch is activated in the following step. You should
use this feature only when you want to de–energize the critical load.
To use the REPO switch:
1. Firmly push the red pushbutton until it locks into place. The switch latches into the activated state (see
Figure 7-8).
The input, output, and bypass backfeed contactors open, the battery breaker or disconnect is tripped, and
the power module is turned off immediately, without asking for verification on all UPSs.
CAUTION
Do not attempt to restart the system after the REPO until the cause of the shutdown has been identified
and cleared.
2. To deactivate the REPO switch in preparation for restarting the UPS, insert the supplied key and rotate
clockwise until the red pushbutton releases (see Figure 7-8). To remove the key, rotate the key back to the
vertical position.
3. Restart the UPSs by following the procedure in paragraph 7.4.1 or 7.4.8.
WARNING
Power is present inside the UPS cabinet until the upstream input feeder circuit breaker is opened.
7.5 Color Touchscreen Control Panel
This section describes how the various screens are used to control and monitor UPS operation. Figure 7-9
shows the location of the color touchscreen control panel on the front door of the UPS. Descriptions of the
control panel functions follow. For a description of the UPS control panel functions, see paragraph 7.6.
NOTE The following instructions are for the Eaton-supplied REPO switch. If a
customer-supplied REPO switch is used, it may not activate in the same manner;
refer to the operating instructions provided with the switch.