E.F. Johnson Company Viking VM600, Руководство по эксплуатации

Страница: 64 / 207

Draft 02 - Sep 1 2015
3-20 Viking Mobile Radio Operating Manual
General Operation
3.3 Radio Inhibit
The radio can receive inhibit commands over the air or through the side port. When the
radio receives an inhibit command the screen goes blank, audio stops, lights turn off, and
most of the controls are disabled. The radio is (from the user’s perspective) frozen. Behind
the scenes, however, the radio is still running. It is waiting for an uninhibit command. If it
receives an uninhibit command, the radio User Interface is enabled and the radio will
operate normally. The general idea behind the feature is fairly simple but there are
exceptions.
• Smartport cannot be used to uninhibit a radio. (Unless an “Allow Uninhibit with RSD”
security policy is on the radio)
• If the radio is rebooted while inhibited, the radio is forced to power up on the channel it
was inhibited on.
• When powering up while inhibited, the backlight and LED will not come on.
• When powering down while inhibited, the display will not display “Powering Down”.
• In conventional mode, the radio waits until the inhibit/uninhibit acknowledgement is
sent before becoming inhibited/uninhibited. This is important mainly for uninhibit
where a race condition existed between the ack being sent and rebooting. If the radio
cannot send the ack, the system will need to retry the inhibit/uninhibit command.
3.4 Setting Squelch
The user can program a menu item, soft button (Lightning Control Head only), or function
button, for squelch adjust. While on a conventional analog channel without emergency or
scan active, the user can select the programmed button or menu item for squelch adjust.
The current squelch setting will show on the display. Using the up and down button on the
Navigation Pad (Lightning Control Head Only) or rotating the select knob on the mobile
radio, the user can adjust the squelch setting to a desired level from -7 to +7. Increasing the
value t7 causes the squelch to open sooner for weaker signals while decreasing
towards -7 has the opposite effects. Pressing the select button will store the new squelch
setting and return the user to the main display.
The squelch level is preset and may not require readjustment. However, if the squelch
threshold needs to be changed on a conventional analog channel, it can be changed in the
same way as though using keypad programming if available. The squelch level is preset
during alignment. If the keypad programming feature is available (see Section 5.14), the
squelch threshold can be changed by the user on each conventional analog channel.
Note
The Keypad Programming feature is available to Federal Government users only.