E.F. Johnson Company Viking VM600, Руководство по эксплуатации

Страница: 107 / 207

Draft 02 - Sep 1 2015
Viking Mobile Radio Operating Manual 5-15
Conventional Mode Features
1 The Talkgroup Lock Feature can be enabled / disabled from a programmable button or
menu. The radio must be on a P25 Conventional Channel or else the radio will bad
beep.
2
Talkgroup Select
a The current functionality of Talkgroup Select is (TG Lock Disabled)
-
User is able to direct entry a Talkgroup or select a Talkgroup from a list. The
selected Talkgroup will permanently replace the selected channel's Talkgroup.
-
If Direct Entry and the Talkgroup does not exist in the radio’s profile, the
Talkgroup is replaced and the radio will automatically enable the Override
Talkgroup Security Settings on the Zone page. The current Override settings will
be used for that Talkgroup since it doesn't reside the radio’s profile.
-
For Direct Entry, a valid Talkgroup of 1 - 65535 must be entered, otherwise the
radio will display Invalid TG and bad beep.
b
If Talkgroup Lock is Enabled, the Talkgroup Select feature will have new
functionality.
-
If Talkgroup is entered via Direct Entry and the talkgroup resides in the Armada
profile, the radio will store the Talkgroup as the Lock Talkgroup and will exit
menu mode.
-
If the Talkgroup is entered via Direct Entry and the Talkgroup does not reside in
the Armada profile, the radio will display Invalid TG and bad beep.
-
If the Talkgroup is selected from the list, the radio will store the Talkgroup as the
Lock Talkgroup and will exit menu mode.
-
If Talkgroup Lock is enabled, no permanent changes will be made to the selected
Talkgroup, only the Lock Talkgroup will be affected.
3
Radio will use the key that is assigned to the active TG unless the Override Talkgroup
Security Settings is active. In that case it will use the security parameters that are
defined in the Security section on the Channels tab.
4 If Talkgroup Lock is enabled, the radio will only use the Lock Talkgroup for the
selected channel. The rest of the channels will use the programmed Talkgroup. If this is
not done, then the radio would only be able to monitor a single TG for all scan
channels.
5
If Emergency is declared while Talkgroup Lock is active, the radio will use the
Emergency Talkgroup first if it is defined. If no emergency Talkgroup is defined, it will
use the Lock Talkgroup.
5.11 Standard Conventional Calls
Standard conventional calls can be placed to other radios monitoring the selected channel.
The proper coded Call Guard squelch tone or code or P25 NAC may need to be
transmitted by your radio for them to receive your call (see Sections 5.4 and 5.13.3).