E.F. Johnson Company Viking VM600, Руководство по эксплуатации

Страница: 56 / 207

Draft 02 - Sep 1 2015
3-12 Viking Mobile Radio Operating Manual
General Operation
2 When the bulk of sand and dust is removed, use the brush to clean the interface joint
between the buttons and Control Head plastic.
3
Position the vacuum nozzle two inches (or more, as required) from the face of the
Control Head. Use the brush to remove any remaining sand and dust.
4 Repeat this procedure until the Control Head is completely clean.
3.1.14 Radio Service
If “UNPROGRAMD” is displayed, the cause can be any of the following:
• An unprogrammed channel is selected. Select a programmed channel.
• The selected channel is programmed for an option that is not installed or an error in
programming was detected. Contact your system operator for service.
If the channel is programmed for a system type not programmed, “DISABLED” is
displayed.
If no characters or all characters appear in the display, the viewing angle may be
improperly adjusted. If some other problem is occurring, turn power OFF and then ON
again to reset the control logic. Also make sure that the controls are properly set and that
the power, external speaker, and accessory cables (if used) are securely plugged into the
back of the radio.
If the radio is completely inoperative, check the Main power and ignition sense line fuse.
If it is blown, remedy the cause if possible and replace it with the same type (1A, 15A). If
the radio still does not operate properly, return it to your system operator for service.
Note
There are no user-serviceable components in the radio. Altering internal adjustments can
cause illegal emissions, void the warranty, and result in improper operation that can
seriously damage the radio.
Note
If the vehicle itself needs to be jump started, the mobile fuses must be pulled before jump
starting to prevent damage to the radio!
3.2 Single Touch
The Single Touch feature allows a Viking radio user to send a predefined Status, Message,
Call Alert, Unit Call, or Interconnect Call by pressing and holding a button. For each
system, up to four buttons in Armada can be programmed for Single Touch. The Single
Touch feature allows a user to bypass the menu and PTT to send a Status, Message, Call
Alert, Unit Call, or Interconnect Call. A maximum of four buttons are programmable to