E.F. Johnson Company Viking VM600, Руководство по эксплуатации

Страница: 43 / 207

Draft 02 - Sep 1 2015
Viking Mobile Radio Operating Manual 2-17
Controls & Display
2.5 External Speaker
An optional 4 ohm, 12 watt external speaker is available from EFJohnson (Part No. 250-
0151-006). This can be used to enhance radio audio or to provide primary audio for a
remote-mount radio. Refer to the
Viking Mobile Radio Installation Guides
for additional
installation information.
Figure 2.16 EFJohnson External Speaker
2.5.1 Internal / External Speaker Programming (Standard Control
Head only)
All Viking mobile radios ship from the factory with the internal speaker in the control
head enabled, and audio is also routed to the 8-pin accessory connector at the rear of the
radio.
If you connect an external speaker to the 8-pin accessory connector (as described in the
installation manual), the internal speaker will not be automatically disabled, and both
speakers will be active.
To disable the internal speaker, proceed as follows:
1
Power up the mobile radio.
2
Press buttons F2 and F5 at the same time, and release (see Figure 2.15).
3
Rotate the Select knob, until display reads “SPKR DSABL”.
4
After a short time-out period, display will read “CYCLE PWR”.
5
Power the radio off and back on, and the internal speaker will be disabled.