Duke GES-102, Руководство оператора с иллюстрированным перечнем запчастей, Страница: 48 / 107

Soft Serve Freezer Model GES-102
38 184559
4b) Cleaning with Mix Stored in
remote Cooler Pull out shelf, transfer
all bags to remote cooler for storage.
Mix must be handled according to
local health codes.
6. Place a clean sanitized container
under the dispensing head.
7. Very slowly open the side spigots and
dispense the semi-frozen product until
it quits dispensing. To eliminate waste,
dispense as much as possible for use
in pints, quarts, and/or novelties.
8. Close spigots. Press L2 & R2 to turn
the MTS pumps “OFF”.
9. Fill rinse container with mix pickup
tubes with cold water. Press L2 & R2
and turn the MTS pumps “ON” and
allow the MTS to fill and pressurize
the cylinders.
Note:
If beater motors run more than 5
min, they will automatically turn off to
prevent excessive wear. Press L1 &
R1 to turn beater on for cleaning.
10. Very slowly open the spigots and
dispense the cold water. Open air
bleed while refilling/ Follow with a
container of warm water and repeat
until the dispensed water is clear.
Drain remaining water from the
cylinders.
11. Press L2 & R2 to turn the beaters and
MTS pumps “OFF”. Close the spigots
12. Prepare 2 gallons (7.5 liters) of
sanitizing solution for each cylinder.
Sanitizing solution must be mixed
according to manufacturer’s
instructions to yield 100PPM available
chlorine solution (example: Stera-
Sheen Green Label). Use warm water
(100° to 110°F or 37° to 43°C).
13. Insert the bag adapters into the
sanitizing solution.
11.1 Draining Product
(continued)
CAUTION
Make sure the freezer
is depressurized before
proceeding.
14. Place an empty container under the
dispense heads.
15. Pull the air bleed plugs up until they
touch the bottom of the switch box.
Open the spigots.
16. Press L2 & R2 to turn the MTS pumps
“ON”. When sanitizer flows out the
bottom of the head, close the air bleed
plugs and allow the MTS to pressurize
the cylinders.
17. Press L1 & R1 to turn the beaters
“ON” and allow them to agitate for 5
minutes.
IMPORTANT:
Do NOT use the “FREEZE” position
with sanitizer or water in the cylinder.
The freezer will be damaged.
18. Slowly open the spigots and allow the
MTS to pump all of the sanitizer out of
the bucket. Leaving the spigots open
press L1 & R1 to turn the beaters
“OFF”. Leave the MTS pumps “ON”
and allow the pumps to force all
remaining sanitizer from the cylinders.
When sanitizer quits flowing, place
the MTS pump to “OFF” position.
19. Refer to Disassembly and Cleaning
Instructions.
Figure 11-2
To view videos on the GES freezer visit: http://www.electrofreeze.com/GES_Videos.aspx