Duke GES-102, Руководство оператора с иллюстрированным перечнем запчастей, Страница: 40 / 107

Soft Serve Freezer Model GES-102
30 184559
Figure 9-3
Figure 9-1 Shaft Seals
CAUTION
To avoid electrical shock or
contact with moving parts,
make sure the control pad is
in the “OFF” position and the
main power switch is off.
9 Assembly
Three Piece Shaft Seal
Correct assembly of the freezer is
essential to prevent leakage of the
product and damage to the freezer. You
will need an approved lubricant (such as
Lubri-Film Plus). Make sure all parts of
the assemblies have been cleaned and
sanitized before assembling. Persons
assembling the freezer must first wash
and sanitize their hands and forearms
with an approved sanitizer.
1. Install the cup seal and o-ring on
the washer (see figure 9-1). Apply
a light amount of approved sanitary
lubricant (such as Lubri-Film Plus) to
the o-ring and the face of the plastic
washer opposite the bell portion of
the seal. Do not allow any lubricant to
come into contact with the bell shaped
rubber portion of the seal.
2. Install the shaft seals over the rear of
the beater shafts. If using the three
piece shaft seal the bell-shaped
portion will be facing the rear of the
freezer (see figure 9-2). Remove
excess lubricant from the drive end of
the beater shaft.
3. Place the scraper blades on the
beater shafts, making sure the blades
are installed properly. Proper blade
installation is with flat side against
cylinder wall. (See figure 9-3.)
—continued
PROPER BLADE
INSTALLATION
IS WITH FLAT
SIDE AGAINST
CYLINDER WALL.
Figure 9-2 Beater Shaft Assemblies
CUP SEAL
WASHER
O-RING
DO NOT
LUBRICATE
CUP SEAL
LUBRICATE
LUBRICATE
To view videos on the GES freezer visit: http://www.electrofreeze.com/GES_Videos.aspx