DResearch – User Manual TeleObserver MR3180
2011-02-03
40
Brightness
Enter a brightness value for the selected camera.
Contrast
Here set the contrast for the recordings.
Saturation
Here set the value for saturation.
Quality
Select the quality for the recordings from the activated camera.
Tip: The lower the quality the lower the storage requirement but also the less detail
retained in the video footage.
Resolution
The following resolutions are available for all analogue cameras: 704x288 Pixel
(2CIF/field) , 352x288 Pixel (CIF)
Formatting of the IP camera is done separately in the camera configuration. (see
the camera manual)
Activate sabotage
detection
This checkbox activates the camera’s sabotage detection function.
When the unit registers sabotage activities (the camera lens is covered, dirty or
cross fading occurs) then a short message is sent and/or a relay is switched.
The video recording itself is not interrupted by sabotage.
This feature is available for all connected cameras. Even for those which are not
activated for recording.
Sabotage detection
sensitivity
Set the sensitivity of the sabotage detection.
The value should match the picture content and not be extreme.
Tip:
Generally constant pictures
higher value
Highly changing picture contents and lightning conditions
low value
Factory setting: 41
Activate motion
detection
Marking the checkbox activates motion detection for the camera.
Motion detection can trigger various actions:
e.g. alarm recording or relay switching
Motion detection
sensitivity
Setting the sensitivity of the motion detection.
The value should match the picture content and not be extreme.
Tip:
Generally little movement in picture
higher value
Lots of movement in picture
low value
Factory setting: 10
Define mask for
motion detection
Motion detection can be deactivated for selected areas of the picture by setting a
mask (privacy zones).
Click the picture areas to add or remove them from the masked area.
Those areas not monitored for movement detection are shown semi-transparent.
