56
ED50
01-2020
DL4615-001
dormakaba ED50 Installation Instructions – Fine cover
Chapter 14
14.9 Fasten arm to ED50 operator
Fig. 14.9.1 Mount drive arm to operator at 12 degrees
Fig. 14.9.5 Torque wrench, 5 mm hex key
14.9.1 Mount drive arm to operator.
WARNING
Use caution when working in proximity of door
and pull arm!.
CAUTION
ED operator axle zero position.
In order to mount the drive arm in the correct
position, the axle must be brought to the zero
position.
1. Set ED operator spring preload to approximately ten
clockwise rotations.
• Axle rotates to the zero position.
TIPS AND RECOMMENDATIONS
Reference Para. 13.6, Operator spring tension.
2. Turn the spring preload back to zero rotations
(fully CCW).
3. Push the drive arm onto the spindle at an angle of
approximately 12⁰ to the ED operator.
4. Rotate the drive arm/spindle approximately 10⁰ in
the door's opening direction (Fig. 14.9.2).
5. Remove the drive arm from the spindle (Fig. 14.9.3).
6. Position the drive arm one tooth in the door's closing
direction (Fig. 14.9.4).
7. Push the drive arm / axle extension onto the spindle
(Fig. 14.9.4).
8. Thread the M8 x 40 mm SHCS into the spindle and
tighten SHCS.
CAUTION
Use torque wrench with hex key socket to
tighten M8 screw to 17 ft-lb [23 Nm].
12°
Fig. 14.9.2 Rotate drive arm 10 degrees in door opening
direction
Fig. 14.9.3 Remove drive arm
Fig. 14.9.4 Install drive arm and axle extension
10°
