ENiQ® Wall Readers & Terminals
_____________________________________________________________________________________
29
Installation procedure
Preparation for
installation
Route the connection cable accordingly and prepare
for connection. Remove the 8-pole screw/plug-in
terminal from the reading module and wire it
according to the respective wiring diagram
A corresponding connection diagram is included with
every reader
Caution!
The reader must be wired up in a de-energised state
i.e. the operating voltage may only be switched on
after the reader has been completely installed.
Flush mounted variant
Use the screws provided to screw the wall bracket to a DIN device box with a device
screw spacing of 60mm.