ENiQ® Wall Readers & Terminals
_____________________________________________________________________________________
66
Recognition of an unauthorised locking medium
The upper LED on the unit at which the locking medium was presented flashes red
briefly twice. The upper red LED goes off on all other units connected.
Independently of whether the locking medium is taking part in the extension of
authorisation or data update (ENiQ AccessManager® Terminal or ENiQ
AccessManager® ITT) or not, the locking medium is rejected if there is no
conventional authorisation available at the time of presentation.
Unit at which the locking medium was
presented
All other units
Permanently open mode
You can use a permanently open card/tag to switch the ENiQ AccessManager®, ENiQ
®
Passive Reader or ENiQ
®
Module Reader open permanently. As long as the mode is
active, all persons have access, no matter whether they have an authorised locking
medium available or not.
Please note! To be able to use the permanently open mode
create the permanently open card/tag according to the description on
page 26.
Setting permanently open
mode
Hold the authorised "permanently open card/tag" directly (1 cm) in front of the ENiQ
AccessManager®, a connected ENiQ
®
Passive Reader or ENiQ
®
Module Reader.
You hear three acoustic signals and the lower LED flashes green three times. Then
the lower LED is lit green permanently.
ENiQ AccessManager®
ENiQ
®
Passive Reader
ENiQ
®
Module Reader
Resetting permanently open mode
Hold the "permanently open card/tag" in front of the ENiQ AccessManager®, a
connected ENiQ
®
Passive Reader or ENiQ
®
Module Reader again.
You hear three acoustic signals and the lower LED flashes green once. The control
electronics return to normal state. The upper LED is lit red permanently again.
