Docomo FOMA D902i, Руководство пользователя, Страница: 311 / 500

309
i-
channel
Basic channels are available for free of service
charge for a set period of time to i-mode subscribers
who use an i-channel compatible terminal, and who
have never signed up for the subscriber line.
However, packet communication fee caused by
viewing detail information from the channel list is to
be borne by the users.
･
For important notes on using Trial channel and
detail information about how to use the service, see
“i-mode User’s Manual”.
In principle, Trail channel automatically begins after a
set amount of time once the UIM (FOMA card) is
inserted and the i-channel compatible terminal goes
into use. If Trial channel does not start automatically,
you can start it by pressing
c
.
Trial channel is available only once per subscriber
line.
Trial channel automatically stops after a certain
period of time following the launch. For information
about how to stop the channel, see “i-mode User’s
Manual”.
INFORMATION
●
blinks during reception of information.
●
Neither ring tone nor vibrator operates at the
reception of information. Likewise, the call indicator
does not light or flash.
●
Tickers are not displayed while the animation is
being played on the stand-by display.
●
You may not receive the information in the default
status. In that case, if you press
c
, the
information automatically appears on the ticker of
the stand-by display.
●
In case FOMA terminal has been turned off or the
information cannot be received due to the
out-of-service area, press
c
and select a
channel for the subscriber that has not signed up.
Then you can receive the information.
●
You can configure i-channel whether to run tickers
of i-channel information on the stand-by display. You
can also set their speed.
●
If you cancel i-channel or i-mode service subscription,
tickers are no longer displayed.
Pressing
c
displays the pre-subscription screen.
Until the cancellation procedure has finished,
however, tickers may be displayed on the screen and
pressing
c
may display the last received
information in the channel list.
Menu 281
Displaying i-channel
Channel List
1
c
The channel list appears.
･
When video/-motion or i- α ppli is set as the
stand-by display:
d81
(i-channel cannot be displayed even if
c
is
pressed.)
2
Select the channel
Your terminal connects to the site and the
information appears.
･
Depending on the situation, information may be
received when displaying the channel list.
Menu 282 / Menu 8215
Changing i-channel settings
Ticker Setting
You can set whether to run tickers of received
i-channel information on the stand-by display.
･
In the default state or when the UIM is replaced, or
when the host address 2 is changed, if the i-channel
information is automatically updated or if you press
c
to display the channel list, the ticker is
displayed and you can set the ticker setting.
Trial channel
Changing the i-channel host
You can change the i-channel host (although you
usually do not need to change it).
a
d96
b
Highlight the user host
z m z
Enter your
terminal security code
c
Select each item to set
z p
･
Host address2 should be filled with the address
of the i-channel host (up to 30 one-byte
characters).
･
Host address is the host for i-mode.
☛
P214
d
Select the host you have edited
z p
● If you enter or change the address of
Host
address2
, the i-channel information will no longer
be displayed on the stand-by ticker. Sometimes,
the information will not be updated
automatically. When you press
c
on the
stand-by display to view the channel list, the
latest information is received and the tickers are
shown on the stand-by display.
Channel List
Next