Dinolift DINO 105TL, Руководство по эксплуатации

Страница: 61 / 82

DINO 105TL
61
19.6 TEST LOADING INSTRUCTIONS FOR REGULAR INSPECTION
1. Place the lift on an even surface with good carrying capacity.
2. Drive the outriggers to their lowest position (the minimum support width).
3. Turn the boom to the side from the tow-bar and lower it on the ground.
4. Put a weighed load of 130 kg onto the platform.
5. Lift the boom to as high as it goes and extend the telescope to its full length
(maximum lifting height).
6. Lower the boom to a horizontal position (maximum outreach).
7. Turn the boom round over 360° and establish the standing stability.
8. Retract the telescope and lower the boom.
After the above mentioned test loadings and the subsequent inspection have been
completed without finding any defects in the structure or stability of the lift, the lift may be
used provided that the reach and platform load restrictions, presented in the reach/platform
load chart of this manual, are observed.
The max. allowed load on the platform is 130 kg
– In conjunction with the first, i.e. start-up, inspection, the lift shall be subjected to an
overload test with an excess load of 50 % and after that the supporting structures shall
be thoroughly inspected.
– In conjunction with the annual inspection the lift shall be subjected to a regular
inspection, a test-run and a test loading with maximum permissible load and a thorough
inspection of the supporting structures.
– The first inspection shall be recorded in the start-up inspection protocol - the test runs
shall be recorded in the protocols for the annual and regular inspection.