Dinolift DINO 105TL, Руководство по эксплуатации

Страница: 59 / 82

DINO 105TL
59
- check the condition of the lifting cylinder bearings and pins and the locking of the pins
•
check the attachment and condition of the telescope cylinder bearings and pins.
•
check the condition of the gas springs
•
check the condition of the master and slave cylinder bearings and pins and the
locking of the pins
- check the condition of the boom joint
•
check the bearing and the pin of the boom joint and the locking of the pin
- check the support outriggers and their footplates
•
check the mechanical structure of the outriggers and the welded seams. The
structures must not show signs of deformations or cracks No fractures or cracks
allowed in the welded seams.
•
check the footplates for deformations, cracks or breaches Also check that the
footplate can turn freely on its joint.
- inspect the boom
•
extend the telescope and check that there are no permanent deformations, dents or
traces of substantial wear in the boom
•
also check the welded seams for wear, cracks or breaches
•
check the boom attachment for cracks or breaches
•
check the condition of the platform brackets
•
check the locking of the platform pin
•
check the condition of the cable chain, its clamp brackets as well as the tightness of
the screw connections
•
check the play and attachment of the gliding surfaces on the boom.
- inspect the platform
•
general condition
•
check that the platform does not show signs of deformations, substantial wear or
buckles
•
check that the handrails, the steps, the gate and the attachment of the gate are in
order
•
check the condition of the platform floor plate
•
check the platform carrier for notable buckles or deformations
- check all the protective covers
•
check the condition of the slave cylinder guard
•
check the condition of the boom end cover, covers of the turning device, the safety
device cover, cover of the platform control centre, the rear light cover, and the
covers of the outrigger limit switches
- perform visual inspection of all the screw connections
- inspect the turning device
•
general condition
•
check the play and attachment of the angular gear
•
check the condition of the gear ring
•
check the play of the turning gear
•
check the tightness of the turning bearing attachment screws