Dinolift DINO 105TL, Руководство по эксплуатации, Страница: 60 / 82

DINO 105TL
60
- check the condition of the chassis
•
general condition
•
check the attachment of the tow-bar to the chassis and the axle
•
check the condition of the overrun and its attachment to the tow-bar.
•
check the axle and its attachment to the chassis
•
check the attachment and condition of the brake wires and rods
•
check the rims, the tightness of the wheel bolts, the tyres and the tyre pressure
•
check the condition of the driving device (option), attachment of the parts and
condition of the covers for the electric components
•
check the condition of the transport support of the boom
– perform a test-run/ test of operating controls with a load of 130 kg on the platform
– also check the operation of the limit switches during the test run (refer to the service
instructions)
•
the limit switches on the outriggers, which prevent the operation of the boom
movements
•
the limit switches on the tow-bar, which prevent the use of the outriggers
– after the test-loading and the test-run make sure that the loading has not caused any
defects, such as fractures or permanent deformations of dangerous nature, on the steel
structures or other loaded parts.
– draw up a protocol of the regular inspection with following articles:
1. inspection form
2. data of repair welds
b) date of repair
c) repaired by whom
d) what was repaired
- when the machine is ready for operation after the annual inspection, mark the inspection
date on the inspection plate affixed to the lift
19.5 EXTRAORDINARY INSPECTION
(INSPECTION AFTER AN EXCEPTIONAL SITUATION)
The inspection is required if the lift has been damaged in a manner which may affect
its strength or safe operation.
- Thus the lift shall be inspected according to the instructions for the start-up inspection.
- perform a test-loading with an overload of 25 % and a stability test of the lift
- a protocol shall be drawn up for the inspection