Dinolift DINO 105TL, Руководство по эксплуатации

Страница: 47 / 82

DINO 105TL
47
Outer ring M12, 115 Nm
Inner ring M14, 215 Nm
– lubricate the joints (see point "Lubrication plan")
18.9.6 Inspect the cylinders, and lubricate the joint bearings
- (See point "Lubrication plan")
- Lower the outriggers into the support position.
– from the chassis control centre, drive the lifting cylinder into its upper position, and
check the connections for tightness and the condition of the piston rod
– from the chassis control centre, drive the lifting cylinder into its lower position, and
check the connections for tightness
– from the chassis control centre, retract and extend the telescope cylinder, and check
the condition and tightness of the cylinder
– lubricate the joints of the lifting cylinder, the telescope cylinder and the levelling
cylinders
– inspect the outrigger cylinders and lubricate their joints
NOTE!
ALWAYS DRIVE THE LIFT INTO A POSITION, WHERE IT IS SAFE TO
CHECK THE CYLINDER
18.9.7 Inspecting the boom and the frame
– extend the telescope and inspect the platform, its attachment and the boom
– inspect the joints of the boom and the play of the sliding pads – readjust if necessary.
Lubricate the sliding surfaces
– inspect the turning device and its attachment, lubricate the turning bearing and the gear
ring (2 nipples)
NOTE!
Excess grease pressure may press out the turning bearing seal.
– check the play at the turning bearing: Max.
allowed axial play is about 1 mm.
– check the attachment bolts of the turning device for tightness: