Dino lift DINO 185XTS, Руководство по эксплуатации

Страница: 86 / 121

86
29. FAULT FINDING
29.1 Error codes of the electric control system

The signal light H12 in the platform control centre UCB, and in
the lower control centre LCB H11 indicate the faults in the
electric control system by flashing an error code.

When the engine is not running, the light is illuminated
continuously.

The error codes shall be read as follows:
1. The start is always indicated by four quick flashes.
2. The pause comes before the essential code.
3. The first digit of the code, i.e. the number of slow flashes (in the example; 3 flashes).
4. Pause before the second digit After the pause restarts from beginning, if the second
digit of the code is 0.
5. The second digit of the code, i.e. the number of fast flashes (in the example; 4
flashes).
6. The pause, after which restart from point 1.
In the example the error code is 34.
29.1.1 Error codes of the control system for the boom

The error codes of the control system for the boom will not be shown unless the
control lever is shifted in the proper direction, the pedal (DMS1) is being depressed,
and the engine is running.

In the error codes of the control system for the boom, the second digit is always 0.
The code will be restarted from the beginning after the “pause” in point 4.
Code Digits Fault
IIII -- 10 The control lever has not been calibrated.
IIII -- -- 20 Error in the solenoid valve
IIII -- -- -- 30 Error in the control lever
1. Start
2. Pause 4. Pause 6. Pause
3. First digit of the error
code
5. Second digit of the
error code
Re-starts
from
beginning