Dino lift DINO 185XTS, Руководство по эксплуатации

Страница: 87 / 121

87
29.1.2 Error codes of the control system for the transmission

The error codes of the control system for the transmission will not be reset until the
fault has been eliminated.

The error codes of the control system for the transmission will be shown when the
operating controls are in the position 0, and the engine is running.

In case more than one error situations are active at a time, only the error code
having the lowest digit combination will be flashed.
* Safe mode (The machine cannot be driven.)
** Limited mode (The machine can only be driven with limited functionality)
IF THE FLASH CODE BEING SHOWN IS NOT PRESENTED IN THE TABLE, CONTACT
A SERVICE PROVIDER WHO IS VERY FAMILIAR WITH THE LIFT
IN THE CASE OF FAILURE, CONTACT A SERVICE PROVIDER WHO IS FAMILIAR
WITH THE LIFT
Code Digits Fault
IIII -- - 11 The battery voltage will be monitored.
IIII -- - - - 13 internal reference voltage failed*
IIII -- - - - - 14 Analogue injection channel *
IIII -- - - - - - 15 Watchdog *
IIII -- - - - - - - 16 Sensor voltage error, nominal 5 V
IIII -- -- - 21 Pump forward control valve error
IIII -- -- - - 22 Pump reverse control valve error
IIII -- -- - - - - - 25 Digital outputs A1 (PCSp03) / A2 (PSC2p04)
IIII -- -- - - - - - - 26 Digital outputs B1 (CC2p10) / B2 (CC2p09)
IIII -- -- -- - 31 Pump/engine speed r.p.m. error/input
IIII -- -- -- -- - - - 43 Driving sensor error **
IIII -- -- -- -- - - - - - - - 47 Mode switch-B error
IIII -- -- -- -- -- - 51 Pump's swashplate angle/swashplate control error
**
IIII -- -- -- -- -- -- -- 70 CAN hardware error **
IIII -- -- -- -- -- -- -- - - 72 CAN software error **