Dino lift DINO 185XTS, Руководство по эксплуатации

Страница: 27 / 121

27
11. MEASURES TO BE TAKEN IN CASE OF EMERGENCY/AT RISK OF
LOSING THE STABILITY
Reduced stability can be caused by a fault in the lift, the wind or other lateral force,
insufficient stability of the standing base or too uneven terrain. In most cases one sign of
reduced stability is the inclination of the lift.
WHEN AT RISK OF LOSING THE STABILITY
1. If there is time, try to find out the reason for the reduced stability and the direction of its
effect. Warn other people on the worksite using the alarm signal.
2. If possible, reduce the load from the platform in a safe manner.
3. Reduce the outreach to the side by retracting the telescope. Avoid abrupt movements.
4. Turn the boom away from the danger zone, i.e. to a position where the stability of the lift
is normal.
5. Lower the boom.
If the stability has been lost as a result of a fault in the lift, repair such a fault immediately.
Do not use the lift until the fault has been repaired and the condition of the lift has
been verified.
IN CASE OF OVERLOADING
The engine shuts down and the movements stop, the red signal light H17 is
flashing and the buzzer sounds intermittently.
1. If there is time, try to find out the reason for the reduced stability and the direction of its
effect. Warn other people on the worksite using the alarm signal.
2. Reduce the platform load.
3. The red signal light is turned off and the sound signal stops as soon as the overload
situation ends. After this the machine can be operated normally.
IN CASE THE POWER SUPPLY IS INTERRUPTED (diesel)
1. Lower the boom using the emergency descent system (see point “Emergency descent
system”).
2. Only the movements of the boom are possible using the emergency descent system.
(NOTE that the movements are much slower with the emergency descent system).