Digital Security Controls Ltd.
7
Private and Confidential
Installation Manual
DATE : 09/30/97
DRAFT
The WLS9000 will also use the Acuity Shroud (08-686) for supporting the microphone on the main unit.
ii
The Remote Sounder will use the existing WLS902/911 Wireless Sounder plastics. They comprise of:
•
RF Siren Case Front (08-166)
•
RF Controller/Siren Strain Relief (08-223)
•
RF Siren Jack Cover (08-225)
•
RF Siren Wall Mounting Plate (08-643)
•
Sounder Back Cover (08-746)
5.0 Detailed Description of Software Feature Set
5.2.1 New Function Key Types
The WLS9000 has the following new Function Key Types:
Status –The Status button on the WLS9000 may be pressed to annunciate the current status of the system. For
example:
“Zones are open. Zone 1. System is OFF. To turn ON, enter your access code. For
more options, press star.”
iii
Pressing this key will internally create a link between the panel, ESCORT5580, and audio portions
of the WLS9000. When voice help is active, the keypad may be used to change status or program any
function of the system. This new key is programmable on WLSKeys to allow wireless initiation of Status.
Status is function key definition [27], and will use Mode Request %1C.
Volume Control – A new function key has been created to allow easy volume control of the voice prompts. When
this function key is pressed for two seconds, the WLS9000 will increment through the four different volume
levels from lowest to highest, cycling back to the lowest after the highest volume is reached.
For example, if the Volume key is pressed for two seconds, and the current Volume is Medium, the
WLS9000 will prompt:
“Volume is High.”
…at the new volume. If the key is held for another two seconds, the WLS9000 will state:
“Volume is Highest.”
…and so on.
iv
This Function Key is Type [28], and uses Mode Request %1D.
Note: this function key only controls the volume of the main WLS9000 unit. Volume for the ESCORT
prompts heard via the phone line are still handled in [*][6].
Memo Record – When pressed, this function key will initiate recording (via the local microphone) of a message.
Recording begins after the three acknowledgement tones are annunciated. The recording can also be ended
by pressing this same function key. This Function Key is Type [29], and uses Mode Request %1E.
Memo Playback – When pressed, this function key will annunciate the recorded message. If there is no message
