Digital Projection POWER 2v, Руководство пользователя

Страница: 96 / 174

Configuring a Video Channel
1. Set Gamma in Image Mode to Preferred Value
2. In the Channel Set-up Menu select the correct input, aspect ratio, colour
temperature and format (i.e. PAL, NTSC, SECAM, S-Video, Component RGB
or Component Y Pr Pb).
3. Using either the Size & Position sub menu or the single press remote control
buttons, adjust the size and position until the image fills the screen exactly.
4. Apply a Pluge Test Pattern (or a test signal or tape which has near blacks and
near saturated whites).
5. Using the single press buttons on the remote control adjust the Brightness so that
the -2% bar disappears but the +2% is still visible. If using a tape, adjust the
Brightness up and then down until the darkest part of the tape stops getting any
darker.
6. Adjust the Contrast upwards so that the white bar of the Pluge pattern or a
saturated piece of tape is just saturating and then reduce again until this stops.
7. If using an NTSC source adjust the Hue to give correct colours.
8. Adjust Saturation to taste (50% is usually acceptable).
Saturation will have no effect on RGB sources.
9. Adjust Sharpness to taste.
Pixel and Phase have no effect on video sources.
CÑ44
System Operation
OPERATION
LBV00018; Revision E - 28/01/98
✍
✍