Digital Projection POWER 2v, Руководство пользователя

Страница: 171 / 174

MODIFY/CREATE
If you selected an existing computer card it is possible to modify a specific mode
for that card. After selecting the mode to be modified from the resolution mode
fly-out list you will enter the 'Mode Parameters' window. The computer and mode
names will be displayed along with the previously defined parameters.
If you selected NEW, the 'Computer Name' window will open asking you to enter
the name of the new computer. After entering the name and selecting OK, the mode
parameters window will appear to allow you to define it's configuration.
COPY
The COPY function permits the user to make a copy of an existing computer card
with all its associated modes and give it a different name. It is not possible to copy
an individual mode, either within a computer card or between cards. To copy a
computer card, select it from the fly-out list and press COPY. After naming the new
version select OK to execute the copy.
IMAGE MODE - allows you to configure the projector for front or rear projection
and to define gamma correction for TV or Film inputs.
USER PREFERENCES - enable you to define the general defaults to be applied
when the projector is turned on.
TEST PATTERNS - are used to check the projectors alignment and performance.
SET ADDRESS - defines an individuals projector's address when using multiple
projectors.
PROJECTOR STATUS - displays lamp information along with the projectors
temperature and memory status. The last four warning issued are also displayed.
SERVICE SET UP - is for qualified technicians only and is password protected.
v
Appendix
APPENDIX
LBV00018; Revision E - 28/01/98