Diamond Products CC7574DKV, Руководство оператора

Страница: 57 / 72

CC7574DKV OPERATOR’S MANUAL
Removing the Cylinder Rod
1. Disconnect the two wires from the solenoid
block valve.
2. Remove the hairpin cotter and clevis pin
from the cylinder rod end.
Clevis Pin
3. Holding the cylinder, remove the hairpin
cotter and clevis pin from the isolator
mount tube.
4. Remove the entire assembly from the saw.
Connecting the Cylinder Rod
1. Fit the cylinder into the cylinder rod end
mount and isolator mount tube.
2. Fit the clevis pin through the cylinder rod
end mount and cylinder rod end. Secure in
place with the hairpin cotter.
3. Fit the second clevis pin through the
isolator mount tube and cylinder u-block.
Secure in place with the hairpin cotter.
Clevis Pin
4. Connect the two wires to the solenoid block
valve according to the wiring diagrams in
the CC7574DKV Parts List.
Battery
WARNING
•
Ignitable explosive gases are emitted
from the battery. DO NOT expose the
battery to sparks or open flames, and
keep the area around the battery well
ventilated.
•
Disconnect the battery prior to servicing
the saw unless stated otherwise.
•
Always keep the battery cable clamps
away from the battery terminals when
the battery is disconnected to avoid
accidental connections while servicing.
•
Always be sure to connect the battery
cables to the proper terminal when
reconnecting.
CAUTION
•
Use a proper battery tester when testing
the battery strength.
•
Use protective eyewear or a face shield
and avoid contact with the skin when
handling/servicing the battery.
The saw contains a charged battery with one
positive cable lead and one negative cable
lead.
Battery
Battery Type
12 Volt, Group 31
57