Diamond Products CC7574DKV, Руководство оператора

Страница: 54 / 72

CC7574DKV OPERATOR’S MANUAL
Regular Maintenance
Speed Control Lever
Adjusting the Lever Tension
Adjust the tension felt in the speed control
lever, when moving the lever forward and
backward, to the desired setting as necessary.
1. Unlatch and lower the rear cover screen.
Access Panel and Allen Wrench
2. Remove the grease cap from the pivot
housing.
3. Loosen the jam nut on the opposite side of
the speed control frame using provided
15/16” wrench.
Grease Cap and Jam Nut
4. Use the Allen wrench, located on the
access panel, to adjust the shoulder screw.
5. Retighten the jam nut.
6. Move the speed control lever forward and
backward to test the lever tension. Readjust
the shoulder screw and jam nut if desired.
7. Secure the grease cap to the pivot housing.
8. Close the rear cover screen and latch to
secure.
Adjusting the Spring Plungers
Adjust the spring plungers if the speed control
lever feels too tight or too loose when moving
the lever forward and backward, or when the
lever is hard to place into or out of the
Stop
position.
1. If the lever is tight it could be caused by
slurry in the speed control components.
Use a spray lubricant on the spring
plungers to free the controller. If this
doesn’t correct the problem continue on to
step 2.
2. Loosen both hex nuts from the speed
control tube.
3. Screw the spring plungers slightly out to let
the speed control lever move easily into
and out of the
Stop position. Screw the
spring plungers slightly in to let the speed
control lever move forward and backward
firmly in the forward/reverse slot.
4. Retighten both hex nuts to secure.
Spring Plunger Hex Nuts
Inner Blade Flange
Inner Flange
54