Diamond Products CC7574DKV, Руководство оператора

Страница: 31 / 72

CC7574DKV OPERATOR’S MANUAL
Control Grip Pushbuttons
The control grip pushbuttons only work with the
ignition key at
ON or with the engine running.
Control Grip Pushbuttons
1. Press the Raise (left) pushbutton to raise
the saw and blade, and release to stop.
Note: Always raise the blade when
maneuvering the saw to provide proper
clearance between the blade and the ground.
2. Press the Lower (right) pushbutton to lower
the saw and blade, and release to stop.
3. Press the Tilt Handlebar pushbutton,
located on the side of the control grip, and
move the handlebar up or down to adjust
the angle.
Fuel System
WARNING
• Always use caution when refueling
• DO NOT operate the saw with a fuel leak
•
DO NOT fuel the saw with the engine
running
•
DO NOT smoke or expose
fuel to open flames when filling
the fuel tank or working
with fuel
CAUTION
• Clean up any spilled fuel prior to
starting the engine.
• Fuel may seep out from the fuel cap
vent (applicable models) when raising
the saw if the fuel tank is overfilled.
Adding Fuel
1. Lower the saw to level the frame.
2. Turn off the engine and let the saw cool
down.
3. Remove the fuel tank cap.
4.
Fill the fuel tank with ultra-low sulfur diesel
fuel. DO NOT overfill the tank for expansion
purposes. Refer to the engine manual for
information on appropriate diesel fuels in
normal and cold weather temperatures,
5.
Replace the fuel tank cap and secure
.
Blade Guard
WARNING
•
DO NOT operate the saw with the blade
guard raised or removed.
• DO NOT remove the blade guard with the
engine running.
• Blade exposure should not exceed 180°
while cutting.
• Always pivot the front of the
blade guard 180° (fully upward)
so the guard does not swing
down unexpectedly, which may cause
serious injuries.
• Always secure the pivoted section of the
blade guard using the detent pin (guards
26” and up)
• When pivoting the front of the blade guard,
raise/lower it cautiously and slowly to avoid
serious injuries.
The blade guard shields the blade and must
always be in place when operating the saw.
Blade guards generally stay in place at all
times, except for when changing to another
guard size or when using the guard on the
opposite side of the saw. Regularly inspect the
blade guard and water tubes. Clean, repair, or
replace dirty or damaged components
immediately.
Note: Always use a guard size that matches
the blade size. Refer to the parts list for
additional information.
31