Diamond Products CC7574DKV, Руководство оператора

Страница: 51 / 72

CC7574DKV OPERATOR’S MANUAL
3. Remove the filter using an appropriate tool.
Dispose of the used oil and filter according
to city, state, and federal regulations.
4. Wipe down the sealing surface with a clean
cloth and use clean oil to lightly oil the filter
gasket.
5. Tighten the new filter to the filter head
following the directions on the filter.
6. Start the engine and let it run for 30
seconds then shut the engine off.
7. Check the level of the hydraulic fluid in the
reservoir tank and add fluid as required.
DO NOT overfill as fluid will leak out from
the reservoir cap.
8. Inspect the seal for leaks and hand tighten
as necessary.
Replace the Fuel/Water Separator Filter
1. Ensure the engine is turned OFF and the
saw frame is level.
2. Unlatch and open the left side door.
3. Locate the drainage cap on the underside
of the fuel/water separator.
Fuel/Water Separator Filter
4. Loosen the cap only enough to allow water
to be discharged from drainage tube.
Do
not remove the cap.
5. When no more water is discharged,
remove the electrical connector from the
drainage cap and remove the cap.
6. Remove the fuel/water separator filter
using a filter wrench.
7. Dispose of the filter according to city, state,
and federal regulations.
8. Lubricate the rubber gasket on the filter
with a film of fuel and hand tighten the filter
onto the filter mount and then turn an
addition 3/4 turns.
9. Reinstall the filter drainage cap and hand
tighten securely.
10. Reinstall the electrical connector to the
drainage cap.
11. Start the engine and check for leaks. If no
leaks are present, turn the engine OFF.
12. Close and latch the left side door.
Replace the Fuel Filter
1. Ensure the engine is turned OFF and the
saw frame is level.
2. Unlatch and open the left side door.
3. Place a container under the fuel filter.
Fuel Filter
4. Remove the fuel filter using a filter wrench.
5. Dispose of the fuel and filter in accordance
with city, state, and federal regulations.
6. Install a new filter on the engine. Lubricate
the rubber gasket on the filter with a film of
fuel prior to installing it.
7. Tighten the filter to 15-18 lb-ft. (20-24 Nm).
8. Start the engine and check for fuel leaks. If
no leaks are present, turn the engine OFF.
9. Close and latch the left side door.
51