Diamond Products CC7574DKV, Руководство оператора

Страница: 16 / 72

CC7574DKV OPERATOR’S MANUAL
•
Always pivot the front of the
blade guard 180° (fully upward)
so the guard does not swing
down unexpectedly, causing
serious injuries.
• Always secure the pivoted section of the
blade guard using the detent pin (guards
26” and up).
•
Use extreme caution when
installing/removing parts of a guard or the
entire guard as guards can be extremely
heavy and may require installation/removal
at moderate heights.
• DO NOT install or remove the blade guard
with the engine running.
•
Always use a blade guard that corresponds
with the blade size.
•
Inspect the blade guard and water tubes
prior to starting the equipment. Clean or
replace dirty/damaged components
immediately.
Fuel Safety
• Always use caution when refueling.
• Store all fuel in appropriate safety
containers.
• DO NOT operate the equipment with a fuel
leak.
•
DO NOT fuel the equipment with the
engine running.
•
Let the engine cool prior to adding fuel.
•
Refer to the engine manual for
recommended fuels.
•
Always use appropriate fuels in cold
weather.
•
Move the equipment away from the
refueling area prior to starting the engine.
•
DO NOT smoke or expose fuel to
open flames when filling the fuel
tank or working with fuel
.
•
Clean up any spilled fuel prior to starting
the engine.
•
Drain the fuel tank and fuel lines when
storing the equipment for longer periods of
time. Refer to the engine manual for
additional recommendations.
Engine Safety
•
Refer to the engine manual as the primary
source for engine safety.
•
Always know how to turn off the engine
quickly for emergency purposes.
•
Make sure the equipment is in neutral
when starting the engine.
•
Fill the fuel tank and check the oil level
prior to starting the engine.
• Keep all body parts away from
rotating equipment parts with
the engine in operation.
•
DO NOT start the engine without the air
filter(s) installed.
•
DO NOT allow dust to enter the air intake
tube when cleaning/replacing air filter(s).
•
Replace damaged components
immediately that may allow dust to enter
the engine.
•
DO NOT leave the engine running
unattended.
•
Always operate the equipment in
well-ventilated areas.
Concentrated engine exhaust can
cause loss of consciousness and/or
death
.
•
DO NOT touch the engine/muffler
assembly with the engine running, and
always let them cool down prior to touching
or servicing the equipment.
•
Handle hot oil carefully when changing the
oil.
•
Let the engine cool prior to removing
pressurized caps (applicable models).
•
DO NOT use any starter substances or
starter fluids (e.g., starter fluid sprayed into
the air filter) when starting the engine using
a glow plug (applicable models). These
materials are extremely flammable and
explosive, and can melt parts or possibly
explode when used to help start the
engine.
Cutting Safety
•
The direct work area should not contain
buried or embedded electrical, gas, or
water lines that could be damaged and/or
cause personal injury while cutting.
•
Turn off all electricity, gas, and water
around the direct work area prior to cutting.
•
Inspect the work area to ensure nothing will
impede full control of the machine at all
times.
•
DO NOT expose yourself or anyone else to
the direct line of the blade when operating
the equipment.
16