Diamond Products CC7574DKV, Руководство оператора

Страница: 44 / 72

CC7574DKV OPERATOR’S MANUAL
Check Hydraulic Fluid Level for Hydro
Pump Assembly
Prior to checking the hydraulic fluid level,
ensure that there is no blade installed on the
saw and the saw frame is in a level position.
1. Check the hydro pump reservoir tank level.
Hydro Pump Reservoir Tank
2. If the level is below the “Full Cold” line
then, remove the reservoir tank cap.
3. Add SAE 15W-40 oil to the reservoir tank
fill line. DO NOT overfill as fluid will leak out
from the reservoir cap.
4. Replace the cap and tighten to secure.
Adding Fluid to the Hydraulic Lift Pump
Hydraulic Lift Pump Breather Cap
Check the fluid daily and add fluid to the pump
as necessary.
1. Lower the saw to level the frame.
2. Unlatch and open the left side door.
3. Remove the hydraulic pump breather cap.
4. Using a funnel, add SAE15W-40 oil or an
equivalent to just below where the fill port
extends into the hydraulic pump. Do not
overfill, as this will cause oil leakage
through the breather cap when raising the
saw.
5. Replace the breather cap and retighten to
secure.
6. Close the left side door and latch to secure.
Checking Radiator Coolant Level
The coolant system is a pressurized system.
Care must be taken when servicing the
system.
Prior to checking the radiator coolant level,
ensure that there is no blade installed on the
saw and the saw frame is in a level position.
1. Remove the cap from the coolant
expansion tank.
Coolant Expansion Tank
2. Visually inspect the coolant level, it should
be to the bottom of the fill tube.
3. If it is below the fill tube add a 50/50 mix of
water and antifreeze as called out in the
CC7574DKV Parts List, to the expansion
tank. Fill only to the bottom of the fill tube,
approximately 50% of tank capacity, to
ensure enough air volume is present for
coolant expansion.
4. Replace the coolant expansion tank cap
and tighten to secure
.
44