Diamond Products CC7574DKV, Руководство оператора

Страница: 46 / 72

CC7574DKV OPERATOR’S MANUAL
Fuel/Water Separator
2. Locate the drainage cap on the underside
of the fuel/water separator.
3. Loosen the cap only enough to allow water
to be discharged from drainage tube. Do
not remove the cap.
4. When no more water is discharged, re-
tighten the drainage cap.
5. Close and latch the left side door.
Lubricate the Hydraulic Cylinder Pivot
Pin
1. Ensure the saw is parallel to the ground.
2. Add one pump of grease into the hydraulic
cylinder pivot pin grease fitting located at
the back of the front axle assembly. To
access it unlatch and open the right side
door. The fitting is located at the frame
base just in front of the cooling fan.
Pivot Pin Grease Fitting
Lubricate Front Axle Pivot Bearings
1. Raise the saw to the full up position.
2. Add no more than two pumps of grease to
each of the two front axle bearings grease
fittings located under the frame base on
both the left and right side.
Front Axle Bearing Grease Fitting
Lubricate the Optional Bogie Wheel
The bogie wheel has two locations for adding
grease. The first is on the wheel axle located
on the side of the wheel. The second location
is on the caster bracket on the back of the
wheel.
1. Add one pump of grease to both grease
fittings located on the bogie wheel.
Bogie Wheel Grease Fittings
46