Dialoc ID MCQ-PRO, Руководство пользователя

Страница: 51 / 89

MCQ-PRO RFID Reader
— Installation and Tuning Manual Version 1.00
Page 51 of 89

With a MCQ-Pro Reader, if this mode is active, the reader uses GPIO Output
#2 to report reading activity. GPIO Output #2 is activated when the reader
“sees” tags in the RF field. The time an output remains active after the
corresponding event has occurred is software configurable.

“Enable Tunnel Feedback” is for DIALOC ID internal use only.

“Enable Scan Once” indicates, when reading asynchronously, that the radio should
automatically stop reading after:
o
In “default RF” read mode: one single round (not valid with C210 & C220
tags).
o
In “multiplexer” read mode: having scan all the existing patterns.
You can configure read mode settings on “Read Mode” tab of “ Read Configuration” panel.
Figure 40: Read Configuration panel (Read Mode tab)
Input Trigger:
Active Level: indicates the active level when radio should start reading (ie: on Low
state “0” or on High state “1”)
Output Feedback:
Duration: indicates the duration in milliseconds of read activity feedback.
Tunnel Feedback:
Those settings are for DIALOC ID internal use only.