Delta InfraSuite RDA037, Руководство пользователя

Страница: 39 / 92

39
Connecting the outdoor unit’s power wire (Use accessory pack item: 4 cable glands)
Cable size:
1. When using indoor unit power supply: Use cabling 16 AWG (1.3 mm
2
) or greater for
power wires and control lines.
2. When using independent power supply: Use cabling 14 AWG (2 mm
2
) or greater for
power wires and control lines.
NOTE:
When installing the cabling lock to the Manual Motor Starter (MMS), pay
attention to the torque; the torque range is 0.8 to 1.2Nm.
Step 1
At the rear of the top/bottom of the indoor unit cabinet, use needle-nose pliers to remove the
knocking-piece at the top/bottom of the cabinet; remove the cable gland from the accessory
package and remove its nut. Rotate and tighten the cable gland on the knocking-piece, and
pass the power wires through it.
(Figure 3-19: Power Wire Outlet)
Cable Gland
Top of the Cabinet Bottom of the Cabinet