Delta InfraSuite RDA037, Руководство пользователя

Страница: 24 / 92

InfraSuite R Series – Air Cooled Type 24
3.1.5 Outdoor Unit Installation
Install the outdoor unit according to the following instructions.
(Figure 3-8: Installing the Outdoor Unit Stand)
1. Open the wooden box and take out the
outdoor unit accessory pack.
2. Combine the No. 1 floor stand X2, No. 2. support
X1, and No. 3 M6 screw X8 of the accessory pack
into a floor stand set (attached at a torque of
45kgf/cm
2 ). There are two sets in total.
Floor Stand Cross Bar
3. Attach the outdoor unit floor stand set to the
outdoor unit body with No. 3 M6 screws
(torque: 45 kgf) in the accessory pack at four
designated places
4. Remove the wood screws and the flat washers of
the outdoor unit’s main unit and install the outdoor
unit upright in the direction of the arrow.
Illustration of the M6
screws on the
outdoor unit’s body
and the floor stand
Expansion Screws
Floor Stand
Floor
5. Move to the installation location. Use SUS 5/16” x 1-1/4” expansion screws to fix the floor stand at four
designated places. The required environment and the working space must be taken into account when
choosing the installation location. If there is a risk of flooding, the unit must be installed on an elevated
surface.
Floor
Stand
Floor Stand
Cross Bar
Illustration of the M6
screw attached to the
outdoor unit floor stand set