Delta AH02HC-5A, Руководство по оборудованию

Страница: 218 / 229

Chapter 9 Troubleshooting
Error
Description Remedy
code
16#9A5B
There is no response from
slave 27 in the PLC Link.
(SM1592)
1. Check the communication setting in the master,
and the communication setting in slave 27.
2. Check the communication cable.
16#9A5C
There is no response from
slave 28 in the PLC Link.
(SM1592)
1. Check the communication setting in the master,
and the communication setting in slave 28.
2. Check the communication cable.
16#9A5D
There is no response from
slave 29 in the PLC Link.
(SM1592)
1. Check the communication setting in the master,
and the communication setting in slave 29.
2. Check the communication cable.
16#9A5E
There is no response from
slave 30 in the PLC Link.
(SM1592)
1. Check the communication setting in the master,
and the communication setting in slave 30.
2. Check the communication cable.
16#9A5F
There is no response from
slave 31 in the PLC Link.
(SM1592)
1. Check the communication setting in the master,
and the communication setting in slave 31.
2. Check the communication cable.
16#9A60
There is no response from
slave 32 in the PLC Link.
(SM1592)
1. Check the communication setting in the master,
and the communication setting in slave 32.
2. Check the communication cable.
16#9A61
The setting of the PLC Link
mode is incorrect. (SM1589) Make sure that SM1586 and SM1587 are not both
ON.
16#9A62
The number of polling cycles in
the PLC Link is incorrect.
(SM1592) If the PLC Link is in the manual mode, please
make sure that the number of polling cycles is
within the range between 1 and 65535.
16#9A63
There is a handshaking timeout
when the CPU module
establishes a connection with
the network module. (SM1596)
Check whether the network module operates
normally.
16#9A64
There is no network module
parameter in the CPU module.
(SM1596)
Download the parameter in HWCONFIG again.
9.2 Troubleshooting for I/O Modules
y
The introduction of modules
Digital I/O modules, analog I/O modules, network modules, temperature measurement modules,
and motion control modules can be installed in an AH500 system. Please refer to AH500 Module
Manual for more information about the specifications for I/O modules. The error codes and the
remedies for the errors are listed below.
9.2.1 Troubleshooting for Analog I/O Modules and Temperature
Measurement Modules
Error
code
Description Remedy
16#A000
The signal received by
channel 0 exceeds the range
of inputs which can be
received by the hardware.
(The ERROR LED indicator
blinks.)
Check the module parameter in HWCONFIG.
Check whether the signal received by channel 0
exceeds the range of inputs which can be received
by the hardware.
9-23