Dell Precision WorkStation 210, Руководство пользователя

Страница: 57 / 247

Using the System Setup Program 3-7
'ULYHV3ULPDU\DQG6HFRQGDU\
Primary identifies drives attached to the primary enhanced integrated drive
electronics (EIDE) interface connector (labeled “IDE1”) on the system board;
Secondary identifies drives connected to the secondary EIDE interface connector
(labeled “IDE2”).
For both the Primary and the Secondary drive sections, the Drive 0 and Drive 1
options identify the type of EIDE hard-disk drives installed in the computer. For each
drive, seven parameters can be chosen as a group by drive-type number, entered
individually from the keyboard or set automatically. A
drive-type number
specifies the
parameters of a hard-disk drive based on a table recorded in the system’s BIOS.
To choose a setting, type characters from the keyboard or use the left- or right-arrow
key to cycle through the choices.
The settings are:
‡
Auto
‡
None
‡
Usr1 or Usr2
‡
A specific drive-type number
NOTES: The
Primary
and
Secondary
drive sections identify
only
EIDE drives.
Operating systems that bypass the system BIOS may not obtain optimum hard-disk
drive performance.
(,'('HYLFHV2WDUG'LVN'ULYHV
For EIDE CD-ROM drives that use the integrated EIDE controller, it is recommended
that you use the secondary EIDE interface connector if a hard-disk drive is attached to
the primary EIDE interface connector.
For all EIDE devices, set the appropriate Drive option to Auto .
(,'(+DUG'LVN'ULYHV
For EIDE hard-disk drives, the system provides an automatic drive-type detect feature.
To use this feature for Drive 0 , highlight the Drive 0 option and type
a
(for
automatic
).
To use it for Drive 1 , type
a
at the Drive 1 option. In each case, the setting changes to
Auto . After you reboot the system, the System Setup program automatically sets the
correct drive parameters for each drive.
Before installing a new EIDE hard-disk drive, also check the documentation that came
with the drive to verify that all jumper settings on the drive are appropriate for your
configuration.
NOTE: If you are using a hard-disk drive that was shipped by Dell, use the Auto
setting.