Dell Precision WorkStation 210, Руководство пользователя

Страница: 139 / 247

Installing Drives 9-3
)LJXUH5HPRYLQJWKH)URQW%H]HO
While pressing the tab release, tilt the bezel away from the chassis, disengage the
two retaining hooks at the bottom of the bezel, and carefully pull the bezel away from
the chassis.
To replace the bezel, fit the two retaining hooks on the bezel into their corresponding
slots at the bottom of the chassis. Then rotate the top of the bezel toward the chassis
until the top tabs snap into their corresponding slots on the bezel.
5HPRYLQJDQG5HSODFLQJ)URQW3DQHO
,QVHUWV
Empty drive bays contain a front-panel insert to protect the inside of the computer
from dust particles and also to ensure proper airflow within the computer. Before you
install a drive in an empty drive bay, you must first remove the front-panel insert.
To remove the insert covering a 5.25-inch bay
,
follow these steps:
1. Turn off the system, including any attached peripherals, and disconnect all the AC
power cables from their power sources.
2. Remove the computer cover as instructed in “Removing the Computer Cover” in
Chapter 7.
3. Remove the front bezel using the instructions in the previous section, “Removing
and Replacing the Front Bezel.”
tab release
retaining hooks (2)