Dell Precision WorkStation 210, Руководство пользователя, Страница: 37 / 247

Introduction 1-11
11. Click Finish .
The system continues its start-up routine. When Windows 95 or Windows 98
finishes loading, a dialog box informs you that the system configuration settings
have changed and asks if you want to restart the system.
12. Click OK to restart the system.
)URQW3DQHO
The computer’s front panel contains the following indicators and controls (see
Figure 1-2):
‡
The
power button
provides control of the system’s AC input power. The
push-button switch operates as follows:
— When the computer is turned off, pressing the button turns the computer on.
— When the computer is turned on, pressing the button turns the computer off.
However, a low-voltage (standby) current is maintained by the power supply.
To completely remove all power from the system, unplug the AC power
cable from its source.
For systems running Microsoft Windows 95 or Windows NT with the Dell
AutoShutdown service operational, pressing the power button causes the
system to perform an orderly operating system shutdown before turning off.
(For more information, see “Dell AutoShutdown Service” in Chapter 2.)
NOTE: A Display Power Management Signaling (DPMS) monitor does not
begin warming up until the computer to which it is attached is turned on .
Thus, some DPMS monitors may not display a video image until several
seconds after you turn on the computer.
‡
The
power indicator
light is green during normal system operation and amber
when the computer is in sleep mode.
‡
The
hard-disk drive access indicator
lights up when a hard-disk drive is in use. (Drive
access indicators for diskette drives and tape drives are located on the front of
the drives.)
‡
The
reset button
reboots (restarts) the system without your having to turn the
power off and then on again. Rebooting the system in this manner reduces
stress on system components.