Dell PowerEdge R910, Руководство владельца оборудования

Страница: 102 / 210

102
Installing System Components
4
Align the memory riser with the slots on the memory-riser guide and the
cooling fan assembly.
5
Insert the memory riser firmly into the card guide until it is fully seated.
6
Press down on the handle until it clicks into place.
NOTE:
You can only lower the handle after the memory riser is seated in the
card guide. If the handle does not move down, verify that the memory riser is
properly seated in the card guide.
7
Close the system. See "Closing the System" on page 90.
8
Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
Installing Memory Modules
WARNING:
The memory modules are hot to the touch for some time after the
system has been powered down. Allow time for the memory modules to cool
before handling them. Handle the memory modules by the card edges and avoid
touching the components on the memory module.
CAUTION:
Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came
with the product.
1
Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2
Open the system. See "Opening the System" on page 89.
3
Remove the memory risers. See "Removing a Memory Riser" on page 100.
4
Pull the release tab and lift the memory module cover in the direction of
the arrow.
book.book Page 102 Wednesday, January 20, 2010 10:20 AM