Dell EMC VxFlex Ready Node R840, Руководство пользователя

Страница: 158 / 218

Che
ck
List Task Topic - left control
panel Topic - right control
panel
☐
10 Install the replacement
control panel.
See Installing left control
panel on page 159.
See Installing right control
panel on page 161.
☐
11 Install the cooling fan
assembly.
See Install the cooling fan
assembly on page 175.
☐
12 Install the air shroud. See the relevant topic,
depending on your
system:
Install the non-GPU air
shroud
on page 169
Install the GPU air shroud
on page 171
See Install the non-GPU
air shroud on page 169.
☐ 13 Install the drive carrier. N/A See Install the drive
carrier on page 72.
☐
14 Install the system cover. See Install the system cover on page 173.
☐
15 Slide the system into the
cabinet.
See Slide the system into the cabinet on page 165.
☐
16 Connect the I/O cables and
power cords.
See Connect the I/O cables and power cords on page
164.
☐
17 Install the front bezel. See Install the front bezel on page 166.
Perform mandatory software tasks to return the node to operation:
☐ 18 Return the node to operation. See "Return the node to operation" in the VxFlex Ready
Node Field Replacement Unit Software Guide .
Removing left control panel
Before you begin
Follow all safety guidelines.
Note
Ensure that you note the routing of the cables as you remove them from the system
board. To prevent the cables from being pinched or crimped, route the cables properly
when you replace them.
Procedure
1. Open the cable latch, and disconnect the control panel cable from the system
board connector.
2. Using a Phillips #1 screwdriver, remove the screws that secure the control panel
and ribbon cable to the system.
3. Holding the control panel and ribbon cable, remove the control panel along with
the ribbon cable away from the system.
Hardware FRU procedures
158 VxFlex Ready Node R840 Hardware Field Replacement Unit and Service Manual