Dell EMC VxFlex Ready Node R840, Руководство пользователя

Страница: 148 / 218

Check
List Task Topic
☐
10 If applicable, install the low profile PCIe
cards. See Install the expansion card into the
expansion card riser on page 105.
☐
11 If applicable, install the expansion card
riser. See Install the expansion card risers on
page 106.
☐
12 If applicable, connect the power cables
to the PCIe card riser. See System board connectors on page
182.
☐
13 Install the system cover. See Install the system cover on page
173.
☐ 14 Slide the system into the cabinet. See Slide the system into the cabinet on
page 165.
☐ 15 Connect the I/O cables and power cords. See Connect the I/O cables and power
cords on page 164.
☐ 16 Install the bezel. See Install the front bezel on page 166.
☐ 17 Verify the new battery in the system and
reset the time and date. See Verify the battery and reset the time
and date on page 149.
Perform mandatory software tasks to return the node to operation:
☐
18 Return the node to operation. See "Return the node to operation after
exiting System Setup" in the VxFlex
Ready Node Field Replacement Unit
Software Guide
.
Replace the system battery
Before you begin
WARNING
There is a danger of a new battery exploding if it is incorrectly installed. Replace
the battery only with the same or equivalent type recommended by the
manufacturer. For more information, see the safety information that shipped
with your system..
Follow all safety guidelines.
Procedure
1. Locate the battery socket. For more information, see System board connectors
on page 182, Item 34, CMOS Battery.
CAUTION
To avoid damage to the battery connector, you must firmly support the
connector while installing or removing a battery.
2. Use a plastic scribe to pry out the system battery.
Hardware FRU procedures
148 VxFlex Ready Node R840 Hardware Field Replacement Unit and Service Manual