Dell EMC E46S001, Инструкция по установке и обслуживанию

Страница: 171 / 184

c Internal PERC riser
d vFlash/IDSDM module
e Internal USB key (if installed)
f USB 3.0 module (if installed)
g Processors and heat sink modules
h Processors blanks (if installed)
CAUTION: To prevent damage to the processor socket when replacing a faulty system board, ensure that you cover
the processor socket with the processor dust cover.
i Memory modules and memory module blanks
j LOM riser card
k Drive cage (rear) (if installed)
Steps
1 Disconnect all cables from the system board.
CAUTION: Take care not to damage the system identification button while removing the system board from the chassis.
2 Using a Torx #T30 screwdriver, remove nine screws securing the system board to the chassis.
Figure 125. System board screws
3 Hold the system board holder, slightly lift the system board, and then slide it toward the front of the chassis.
4 Incline the system board at an angle, and lift the system board out of the chassis.
Installing and removing system components 171