Dell EMC E46S001, Инструкция по установке и обслуживанию

Страница: 46 / 184

System Setup details
The System Setup Main Menu screen details are explained as follows:
Option Description
System BIOS Enables you to configure BIOS settings.
iDRAC Settings Enables you to configure the iDRAC settings.
The iDRAC settings utility is an interface to set up and configure the iDRAC parameters by using UEFI (Unified
Extensible Firmware Interface). You can enable or disable various iDRAC parameters by using the iDRAC settings
utility. For more information about this utility, see
Integrated Dell Remote Access Controller User’s Guide at
Dell.com/poweredgemanuals .
Device Settings Enables you to configure device settings.
Service Tag
Settings Enables you to configure service tag settings.
System BIOS
You can use the System BIOS screen to edit specific functions such as boot order, system password, and setup password, set the SATA
and PCIe NVMe RAID mode, and enable or disable USB ports.
Viewing System BIOS
To view the System BIOS screen, perform the following steps:
1 Power on, or restart your system.
2 Press F2 immediately after you see the following message:
F2 = System Setup
NOTE: If the operating system begins to load before you press F2, wait for the system to finish booting, and then restart
the system and try again.
3 On the System Setup Main Menu screen, click System BIOS .
System BIOS Settings details
The System BIOS Settings screen details are explained as follows:
Option Description
System Information Provides information about the system such as the system model name, BIOS version, and Service Tag.
Memory Settings Provides information and options related to the installed memory.
Processor Settings Provides information and options related to the processor such as speed and cache size.
SATA Settings Provides options to enable or disable the integrated SATA controller and ports.
NVMe Settings Provides options to change the NVMe settings. If the system contains the NVMe drives that you want to
configure in a RAID array, you must set both this field and the
Embedded SATA field on the SATA Settings menu
46 Pre-operating system management applications