Datasat XD20, Инструкция по установке и эксплуатации

Страница: 112 / 254

XD20 Installation and Operating Guide Version 1.1
Document # 9301H264001.1 98
If an error occurs, the following message appears. Check that the Master settings have been saved on the
USB device.
7.8.2.3. Copy
Use this menu to load the configuration files from a USB memory device that may contain configuration
files for several XD20 units. The configuration files on the USB memory device are those that have been
stored by using the Configuration/Store function (see
XD20 Configuration ,on page 95).
Each XD20 configuration is identified by the MAC address. Use the MAC address to identify the XD20
unit to copy the configuration from.
This function may be used if an XD20 is being replaced, and the new unit requires the configuration of
the one being replaced.
1. First you need to determine the MAC address of the XD20 being replaced, or copied. From the
Ready message on the LCD status display, press Enter and select Menu
→
Info
→
Mac
Address to view the MAC address. Write down the MAC address that is displayed.
2. Then select Copy from the USB Memory menu.
If you have not inserted a USB memory device into the USB port, a message will appear,
prompting you to do so.
3. Insert the memory device into the USB port. A list of the MAC addresses on the memory device
will display, as shown here.
System
→
USB Memory
→
Copy
4. Scroll through the list to find the MAC address that matches the address of your XD20. Position
the cursor next to it.
5. Press Enter to copy (load) the settings associated with the selected MAC address onto
the replacement XD20.
The following message displays if the XD20 configuration successfully loads.
6. When you press Enter , the following message appears on the screen. Restart the XD20 before
continuing to use it. (Turn XD20 off and then on again, to restart.)