Datasat XD20, Инструкция по установке и эксплуатации, Страница: 104 / 254

XD20 Installation and Operating Guide Version 1.1
Document # 9301H264001.1 90
7.7. Playlist
The playlist setup is a series of menus used to set the delays and options for the video playlist. To access
the Playlist menu, select
Playlist from the Automation /Control menu, as shown below:
The Select Playlist menu, shown below, appears on the screen.
Setup
→
Automation
→
Playlist (Select Playlist)
Preshow Select to edit the automation options for the Preshow playlist.
Intermission Select to edit the automation options for the Intermission playlist.
Playlist C-G Select to edit the automation options for Playlists C - G.
ACV Select to edit Alternate Content Video.
Use the ▲ and ▼ buttons to display the desired playlist and then press Enter or ► to edit the Playlist
Automation option. Press ◄ to return to previous menu.
Edit the option with the correct selection for that playlist. The following values may be set for each type
of playlist:
•
Video Start Delay (0 to 120 seconds)
•
Output Start Pulse (Enable/Disable)
•
Start Pulse Delay (0 to 120 seconds)
•
Output End Pulse (Enable/Disable)
•
End Pulse Delay (-60 to +60 seconds)
•
Lamp off command at end of playlist
•
End of playlist format
•
Format for silent video clips
•
Loop at end of playlist
7.7.1. Video Start Delay
The Video Start delay is the amount of time XD20 waits after receiving the “start” command (to start
playing videos from the playlist). This is used to allow the video projector lamp time to
warm up.
Automation
→
Playlist (Option 1)
0 to 120 Number of seconds XD20 waits for the projector to warm up.