DataCard LM200, Руководство пользователя

Страница: 28 / 138

18 Using the Printer and Laminator
Loading Bottom-Side Laminate Film
1.
Open the laminator door by pulling the top of the door toward you.
2.
Remove the bottom ‐ side film cartridge:
Press the laminator cartridge release button and remove
the laminator cartridge carefully. The material must be
tight when removing the cartridge.
3.
Remove the used material (if present).
Be sure to save the empty supply spool. (Do not throw it
away.) Use the empty spool as the take ‐ up spool in step 4 ,
of this procedure.
4.
Place the new roll of material next to the empty take ‐ up spool on a clean surface.
5.
Remove the label from the laminate material and use it to
secure the free end of the material to the empty take ‐ up
spool, making sure that the edges are even.
6.
Load the new roll of material on the cartridge:
a.
Put the full roll of material on the supply spindle.
b.
Put the empty take ‐ up spool on the take ‐ up spindle.
c.
Align the material along the four metal guides as
shown on the cartridge label.
d.
Wind two or three rotations of film onto the take ‐ up
spool. Take up slack between the spools by turning
the supply knob counterclockwise. If slack cannot be
removed, verify that the supply and take ‐ up spools
are firmly seated on the spindles.
7.
Replace the loaded laminator cartridge in the laminator
until it clicks into position.
8.
Close the laminator door.
9.
If the loading status of the cartridge is changed when
changing the side to be laminated, the laminator does
not initialize when the laminator door is closed. Press the
Operator button to initialize the laminator.
Take-up Spool
Supply Roll
Guide Shaft
Metal Guides
Operator Button